A flat, level surface is required. Any of the following is acceptable:
• Minimum 3.5″ thick foundation of reinforced concrete
• Pavers set in Concrete
• Wood/composite decking

The enclosure comes with all parts and material needed for installation. The shipment consists of tracks, polycarbonate panels with aluminum extruded arches, doors, and all necessary hardware with an installation manual.

Manufacturer’s limited warranty applies:

• Polycarbonate panels: Ten Years
• Aluminum arches and surface finish: Five Years
• Consumables(rubber, brushes, etc.): Two Years as per Manufacturer of product
• Installation, if performed by the manufacturer/authorized installer: Two Years

The enclosure is held to the track which in turn is anchored to the ground. This allows for easy operation and added security from heavy snow loads or during higher wind conditions.

If a pool enclosure is shipped to you with the segments fully built (under 7’6”)  a local handyman, pool company or handy homeowner can do the install. Typical pool enclosures require 2-4 people and take one to two days to install. A spa dome enclosure install typically require 2-3 people for a one day install.

The enclosures are designed for an easy install by an authorized installer or a local qualified contractor in your area

The building permit requirements are determined by your local city or municipality. If a permit is required, we can provide you with necessary documentation for you to obtain permit approval.

Unload is easy with the help of a rollback tow truck. Here is link to instructions.

While very little maintenance is required, if you live in an area that produces a lot of dirt or dust, then occasional cleaning may be needed. The polycarbonate panels can be easily cleaned utilizing a soft sponge or cloth made from 100% cotton using lukewarm water and a mild dishwashing detergent. Utilization of a pressure washer with a fanned nozzle and mild detergent can also be used to help clean hard to reach areas.

General guidelines:

• Never use abrasive or high alkaline cleaners on any polycarbonate product
• Do not leave cleaners on polycarbonate for extended periods of time. Rinse immediately with cold, clean water.
• Do not apply cleaners in direct sunlight.
• Never use sharp objects, squeegees or razors on polycarbonate.
• Always practice safety first and never step directly on a polycarbonate panel.
• Always test cleaners in a small inconspicuous area prior to cleaning entire panel to insure against adverse results.
• Avoid allowing the pressure washer spray tip to come too close to the panel.
• Avoid cleaning while dry, as sand and dust particles clinging to the exterior of the panels may scratch the surface.

It shouldn’t as it is not considered a permanent structure, to be sure, please check with your local municipality.